Geosynthetics. Determination of friction characteristics - Direct shear testWhat is this standard about? This document specifies an index test method to determine the friction characteristics of geosynthetics in contact with a standard sand as described in EN 1961, i. e. with a specified density and moisture content, under a normal stress and at a constant rate of displacement, using a direct shear apparatus. The same testing procedure can be used with any type of soil with the density and moisture content that are required

d) overlay and parquet

It is suitable for use as cable protection in areas where wiring is subject to contamination by aircraft fuels and hydraulic fluids

BS ISO/IEC 29109-1:2009 Information technology

for its associated readout system

12 Presentation of test results

This standard fills a gap in the BS 7121 series and is cited in the HSE’s guidance to the Lifting Operations and Lifting Equipment Regulations 1998

this is a technical revision which supersedes BS EN 60958-4:2003+A1:2008

BS 5974 makes recommendations for the selection

Why should you use ISO 55000 - Asset management principles

establishes requirements for safety lifecycle phases and activities which shall be applied during the design and development of the safety-related software (the software safety lifecycle model)

BS EN 13146‑7 is applicable to systems with and without baseplates on all types of sleepers

ISO 22282-3 attempts to address the limitations of certain testing procedures without restricting the required equipment too stringently