VTL Rotary Vane Vacuum Pumps 40 to 105m3/hr - SPECIAL DISCOUNTED PRICESVacuum pumps VTL 40 G1, 50 G1, 65 G1, VTL75 G1 & VTL105 G1 These vacuum pumps have a suction flow rate form 40 up to 105m3 hr. The vacuum lubrication with oil recirculation is adjusted via two oilers located in correspondence of the support bearings. The rotor is cantilevered fitted on the motor shaft and supported by independent bearings housed in the two pump flanges. The pump and the electric motor are, therefore, two independent units and fixed

suitably finned

allow a certain quantity of fluid to go through

The check valve built into the suction connector maintains the vacuum in the event of a power outage

preventing them from entering into the vacuum pumps

it can be discharged via a convenient discharge hose

it is connected to a vacuum cup

A state of the art range of ejectors has allowed creating this range of pneumatic suction pumps featuring an excellent ratio between the amount of consumed air and sucked air

FS syphon suction filters (for liquid removal)

These cups are produced in a special compound called BENZ

The cartridges described below are suited for FCL filters

wooden panels

The supports illustrated and described on this page are made in anodised aluminium as a standard but